+44 (0)24 7671 8970
More publications     •     Advertise with us     •     Contact us
 
News Article

Making silicon devices responsive to infrared light

News

A novel laser doping method could enable new infrared imaging systems

Scientists have tried a variety of methods to develop detectors that are responsive to a broad range of infrared light - which could form imaging arrays for security systems, or solar cells that harness a broader range of sunlight's energy - but these methods have all faced limitations.

Now, a new system developed by researchers at five institutions, including MIT, could eliminate many of those limitations.

The new approach is described in a paper published in the journal Nature Communications by MIT graduate student Jonathan Mailoa, associate professor of mechanical engineering Tonio Buonassisi, and eleven others.

Silicon lets most infrared light pass right through. This is because the material's bandgap requires an energy level greater than that carried by photons of infrared light. "Silicon usually has very little interaction with infrared light," Buonassisi says.

Various treatments of silicon can mitigate this behaviour, usually by creating a waveguide with structural defects or doping it with certain other elements. The problem is that most such methods have significant negative effects on silicon's electrical performance. They only work at very low temperatures or only make silicon responsive to a very narrow band of infrared wavelengths.

The new system works at room temperature and provides a broad infrared response, Buonassisi says. It incorporates atoms of gold into the surface of silicon's crystal structure in a way that maintains the material's original structure. What's more, it has the advantage of using silicon, a common semiconductor that is relatively low-cost, easy to process, and abundant.

The approach works by implanting gold into the top hundred nanometres of silicon and then using a laser to melt the surface for a few nanoseconds. The silicon atoms recrystallise into a near-perfect lattice, and the gold atoms don't have time to escape before getting trapped in the lattice.

In fact, the material contains about 1 percent gold, an amount more than a hundred times greater than silicon's solubility limit. Normally, this is as if one put more sugar into a cup of coffee than the liquid could absorb, leading to accumulation of sugar at the bottom of the cup.

But under certain conditions, materials can exceed their normal solubility limits, creating what's called a supersaturated solution. In this case, the new processing method produces a layer of silicon supersaturated with gold atoms.

"It's still a silicon crystal, but it has an enormous amount of gold near the surface," explains Buonassisi. While others have tried similar methods with materials other than gold, the MIT team's work is the first clear demonstration that the technique can work with gold as the added material, he says.

"It's a big milestone, it shows you can do this," Mailoa adds. "This is especially attractive because we can show broadband infrared response in silicon at room temperature." While this is early-stage work, for some specialised purposes - such as a system for adjusting infrared laser alignment - it might be useful relatively quickly.

This use of gold was a surprise. Usually gold is incompatible with anything involving silicon, Buonassisi says. Even the tiniest particle of it can destroy the usefulness of a silicon microchip - so much so that in many chip-manufacturing facilities, the wearing of gold jewellery is strictly prohibited. "It's one of the most dangerous impurities in silicon," he says.

But at the very high concentrations achieved by laser doping, Buonassisi maintains that gold can have a net positive optoelectronic impact when infrared light shines on the device.

He adds that while this approach might lead to infrared imaging systems, its efficiency is probably too low for use in silicon solar cells. However, this laser processing method might be applicable to different materials that would be useful for making solar cells.

A paper describing this work has been published online in, "Room-temperature sub-band gap optoelectronic response of hyperdoped silicon," by Jonathan P. Mailoa et al in Nature Communications, 5, 3011, published online 2 January 2014.    doi:10.1038/ncomms4011

This research was funded by the U.S. Army Research Office, the National Science Foundation, the U.S. Department of Energy, and the MIT-KFUPM Centre for Clean Water and Energy, a joint project of MIT and the King Fahd University of Petroleum and Mining.

Adapted with permission of MIT News. (Making silicon devices responsive to infrared light)

Purdue, imec, Indiana announce partnership
Resilinc partners with SEMI on supply chain resilience
NIO and NXP collaborate on 4D imaging radar deployment
Panasonic Industry digitally transforms with Blue Yonder
Global semiconductor sales decrease 8.7%
MIT engineers “grow” atomically thin transistors on top of computer chips
Keysight joins TSMC Open Innovation Platform 3DFabric Alliance
Leti Innovation Days to explore microelectronics’ transformational role
Quantum expansion
indie launches 'breakthrough' 120 GHz radar transceiver
Wafer fab equipment - facing uncertain times?
Renesas expands focus on India
Neuralink selects Takano Wafer Particle Measurement System
Micron reveals committee members
Avoiding unscheduled downtime in with Preventive Vacuum Service
NFC chip market size to surpass US$ 7.6 billion
Fujifilm breaks ground on new €30 million European expansion
Fraunhofer IIS/EAS selects Achronix embedded FPGAs
Siemens announces certifications for TSMC’s latest processes
EU Chips Act triggers further €7.4bn investment
ASE recognised for excellence by Texas Instruments
Atomera signs license agreement with STMicroelectronics
Gartner forecasts worldwide semiconductor revenue to decline 11% in 2023
CHIPS for America outlines vision for the National Semiconductor Technology Center
TSMC showcases new technology developments
Alphawave Semi showcases 3nm connectivity solutions
Greene Tweed to open new facility in Korea
Infineon enables next-generation automotive E/E architectures
Global AFM market to reach $861.5 million
Cepton expands proprietary chipset
Semtech adds two industry veterans to board of directors
Specialty gas expansion
×
Search the news archive

To close this popup you can press escape or click the close icon.
Logo
×
Logo
×
Register - Step 1

You may choose to subscribe to the Silicon Semiconductor Magazine, the Silicon Semiconductor Newsletter, or both. You may also request additional information if required, before submitting your application.


Please subscribe me to:

 

You chose the industry type of "Other"

Please enter the industry that you work in:
Please enter the industry that you work in: